|
|
|||||||
| Show Us Your Knives CKCA members, post photos of your newly made and/or existing knives from your collections or photo galleries. However, please do not make any reference to sale, as this is a place to showcase custom knives not a classified forum. We do have a "Classifieds" sub-forum at the bottom. |
 |
|
|
Thread Tools | Display Modes |
|
#1
12-15-2009, 07:19 AM
|
||||
|
||||
Two previously posted..
..but lost during the changeover.
Forum works and looks great, thanks for all the hard work ! From Don Hanson III. 4 1/2" W2 blade and bronze guard/pin mated to some primo looking walnut.     Thanks, Don ! Chris Moss. OAL: 18.75" Blade length: 12.25" width: 1.5" average Blade thickness: .25" tapering towards the tip. Blade and spacer are 74 layer 1084/15n20 i forged on a Iron Kiss Hammer, and the blade has been laddered toward the edge. Guard is raindrop pattern damascus Handle is Desert Ironwood secured by a stainless steel pin through the tang. Blade was finished to 600 grit, etched and then protected with metal wax.       Doug
__________________
knives 
|
|
#2
12-15-2009, 09:22 AM
|
|||
|
|||
|
I like the way Don , and others, make the tang hefty for hard use. Well made and good to look at too. The knife Don, the knife!
 Lin
|
|
#3
12-15-2009, 02:51 PM
|
||||
|
||||
|
Thanks for sharing Doug.
It's not often we see smaller knives from Don and that one is a fine example. Its good to see these younger makers such as Chris coming onto the scene and doing such outstanding work.
__________________
 Click on logos for info My Collection & Available Knives: http://www.kevinjonescustomknives.com/
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
